xx4 rear shock tower screws idea!!!

[ashleyb4]

This is purely a random idea.

But tonight went to take the shock tower off my xx4 to allow me to get to rear pivot block and i stipped the head off a screw. Can only think it was just an old used screw as it was a brand new allen driver and i mean brand new only a few days old. But to get it out i had to go though the whole process of cutting a flat head head screw into it which was a pain in the a*se you always catch the chassis a bit. So i had an idea i snapped a screw off in my cr chassis and to get it out i wound a screw in from the other side. So i was thinking if i was to drill the holes down so they went straight though the tower and came out the top and extended the thread up. If or when i strip another screw i can just wind another in from the top to push the other out.

Feedback???? Good idea??? Bad Idea??? could this damage the thread in the tower as i know losi graphite isnt the best for holding threads.

A