|
||
|
 |
|
||||||||||||||||||
|
#1
06-07-2009
|
||||
|
||||
7/64" drill bits
The exact right size to 'clean out' the pivot pin holes on a B4. Use these to put right the new moulded parts (30 degree caster blocks) that are, shall we say, a little tight!
Can also be used to clean dirt out of used parts during a rebuild on used parts - just turn the drill in the wishbone by hand. £2 posted - Paypal Gift payment. G
__________________
Graham North http://www.atomic-carbon.co.uk https://www.facebook.com/atomiccarbon https://www.facebook.com/nortechracing 
|
|
|
Threaded Mode