B4 wheels on the Pro-X

[DCM]

Did this testerday, to narrow the front a little, stop front wheel binding, plus I got a few B4 wheels as is, plus I got loads of Proline fitment rear wheels.

I bought the steering arms, axles, bearings, for the B4, reamed out the kingpin hole to 3mm, fitted a spacer above, and it just slid right in, narrowed the front by about 4mm, maybe 5mm.

Rear, until they get the Proline fitment rear CVD's (which I hope comes with an axle spacer and wheels spacer), I used the front dogbones out of the DB-01 and the rear half shafts, trimmed down to clear the wishbones.

Works a treat.