|
||
|
 |
|
||||||||||||||||||
|
#1
10-05-2010
|
||||
|
||||
Brushless gearing
Hi, I am new to brushless motors and need a bit of advice on gearing. I am running a GTB with a 13.5 ex motor in a TC4 on carpet. The 1st temp reading was around 75c so I droped down a pinion to see if it would bring the temp down but it went up
 Can being under geared cause high temp aswell as over geared? I was running an fdr of 6 but on the novak site it says it should be 4.5 which seams quite high? and means a jump of about 10 pinions Any advice gratefull 
|
|
|
Threaded Mode