Thanks to ORB Racing you can now get these Mr. ED designed suspension arms for your favorite Works Dogfighter.
Features:
- Designed to be a direct fit for the Yokomo Works '91, Works '92, Works '93 and Hot Dog (pictured).
- Ready-to-mount: dyed in black, with reamed and threaded holes.
- Using design clues reminiscent to the early Dog Fighter (YZ870C and YZ10) style.
- Optimized for strength in combination with state-of-the-art 3D printing technology.
- Suited for use with big volume shocks. (Requires a small spacer between the arm and lower shock ball.)
- Fixed medium length wheelbase. (No pesky little spacers in the rear arm at the axle carrier.)
- Extra degree of toe-in at the rear axle carrier.
- Mr. ED logos accentuate the custom look.
Pricing and order info:
- 50 for the full set of 4 arms
(Left and right arms are identical. Shipping is typically around 5 within Europe)
Orders and shipping cost inquiries are made directly with ORB Racing :
[email protected]
Your parts will be printed on order: currently there is no stock. So, ask for the expecte time of delivery to avoid unpleasant surprises
More pic's:
Front end
There's a tad of play ; back and forth where the arms meet with the bulkheads. I will leave that in though as the plastic bulkheads I used to test the first prototype were a tight fit. Now they fit both plastic and alu (or magnesium?) bulkheads. And one could still shim if needed.
Rear end with fixed wheelbase: middle
Bottomview: symmetrical arms, so if you have spares they'll fit whichever side you manage to break.
Mount point for the rear and front stabilizers are included (NOT pre-threaded)
Detail showing the texture and finish of the 3D prints
24-11-2017
ADV. Now available for your favorite Yokomo!
Threaded Mode