|
#1
|
|||
|
|||
![]()
Hi,
I am pretty sure that most notice the wobble on the DEX and DESC diffs. I read about using two washers to solve this, but could not find some pics showing this idea. So, my solve of the problem was easy, but you need access to a lathe. First, I make two brass washers (4.98x7x2.6mm) and install them on each diff out drive. ![]() Second, I make a tool for holding the plastic side into chuck. The metal gear does not need this. ![]() Using a carbide mill I drill a 7mm hole in each side of the diff, one in gear, one in plastic body. Then, by using a plastic hammer I press the bushings in place. ![]() ![]() ![]() |
#2
|
||||
|
||||
![]()
Realy nice work, radu!
![]()
__________________
Greetings from Austria! My cars: CatK2/CougarSVR/BossCat/Dex410v3/Dex410v5/Dex210/Dex210F/Yokomo yz-10‘94/Yokomo yz-10‘95/ |
![]() |
|
|