|
#1
|
||||
|
||||
Advice needed - B5 parts on a B4
Will a B5 or B5m front caster/steering block fit onto a B4 front arm?
Many thanks in advance for your advice.
__________________
Team Serpent UK - SRX2MH & SDX4 Absima power - Rudebits - TMG Speed |
#2
|
|||
|
|||
Im pretty sure the hinge pins are a different diameter. I'll check later and get back to you if they are the same.
Thinking about it, the B4 fr axles wont fit the B5 steering blocks. |
#3
|
||||
|
||||
Thanks.
There's a complete set on ebay. Caster and hubs. Just fit and bolt on the (hex) wheels. Thought it might add more options for me to get confused over.
__________________
Team Serpent UK - SRX2MH & SDX4 Absima power - Rudebits - TMG Speed |
#4
|
||||
|
||||
In a short answer, no.
B4 is imperial, B5 is metric. However you could adapt it to fit. Why not just buy the B4 hubs with hexes if that's what you want?
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#5
|
||||
|
||||
Hi Mark,
I hate imperial screws. I have the hex set up at the moment. Just when I saw this front caster blocks I wondered if it would fit with the hinge pins. I've seen a few items, rear hubs etc, that say B4 and B4 so wondered if it would be ok to mix and match a few things.
__________________
Team Serpent UK - SRX2MH & SDX4 Absima power - Rudebits - TMG Speed |
|
|