|
#1
|
||||
|
||||
B74 to wide?
The b74 doesn’t seem to fit in the box at the technical inspection. What’s everybody doing to get to the legal width?
|
#2
|
||||
|
||||
Hi,
Is it off by much? Could you grind the axles down to make it fit? MiCk B. :-)
__________________
http://www.dublinmodelracing.com/ (Off-road racing in Dublin) http://www.p-dubracing.co.uk (Stocking: 8Racing / AVID / GHEA / Xpert Racing / Factory R/C / Alton Design Innovations) http://www.msdmodels.ie/ (Trackside and on-line RC supplies.) |
#3
|
||||
|
||||
It's only catching on the front axles, which is pretty common on modern 4wds. Low profile nuts (either JC or Losi) and trim the front axles a touch.
Just like this: |
#4
|
||||
|
||||
It really peeves me off with this technicality. You’re gaining no advantage by having the axle foul the box and you’re loosing nothing when you’re forced to grind them down. Nothing on the car has changed by grinding the axles to fit in a box. The track hasn’t changed. The camber change through the suspension travel hasn’t changed. Wheel size or width hasn’t changed. Nothing changes by making this alteration.
__________________
CML Distribution - Distributors of Quality Radio Control Models & RC Hobby Products Last edited by Big G; 07-12-2019 at 07:06 PM. |
#5
|
||||
|
||||
Quote:
which everyone must be happy with as there is never a proposal to change it.
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#6
|
|||
|
|||
Maybe the committee should take it on themselves to work out which rules *actually* mean what they *actually* say and which don't.
|
#7
|
|||
|
|||
Why don't the manufacturers just make them fit in the first place?
|
#8
|
||||
|
||||
I agree that this rule can be a little frustrating, but if the car won't fit in the box due to the axles being too long, then how can scruitineering check to see whether the car is too wide at any other point during the suspension up and down travel? Nothing 20 seconds and a dremel won't fix
|
#9
|
||||
|
||||
Because they don't have the same width rule in the US meaning the cars are fine.
__________________
{CML Distribution} {Penguin Bodyshells} |
#10
|
|||
|
|||
I assume the world champs have the same rules for all. Surely they should be adopted the world over
|
#11
|
||||
|
||||
So if I had an old school antenna that hung in an arc but happened to be sideways rather than backwards it would hit the box and the car would fail too. Some rules make no difference at all.
The box should be an inch tall which would still stop cars exceeding the pre arranged width/track limit but wouldn’t fail on blooming axles scraping. I’ve even been told at national meetings to just make sure I dremel them down for the next round and been let through to run in round 1 so it can’t be all that important. Shaving of the axles makes zero difference to my cars setup or geometry and if you wanted to pick hairs saying it’ll lighten the car it’ll give the car an advantage so really they’re stopping a car running until it’s been given an advantage haha |
|
|