|
|||||||||||||||
|
#1
|
||||
|
||||
![]() This is a great idea. But the mounting holes are bigger than the 4-40 screws, so they tend to rotate. I put one countersunk screw in place for one of the holes, which helped some. And I could grind them down to fit both holes, which would hold it perfectly in place. camberlinkextender.jpg But something tells me Big E has a simple and effective solution?
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom Last edited by SHY; 13-05-2008 at 02:24 PM. Reason: Bored at work |
|
#2
|
||||
|
||||
|
I just used a couple of M3 8mm screws for each side.
Just right. |
|
#3
|
||||
|
||||
|
But then you drilled/tapped the plastic to 3mm as well first?
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
|
#4
|
|||
|
|||
|
To be honest I never had an issue with them moving, just tightened them up??
E. |
|
#5
|
||||
|
||||
|
Yes, that's a point. But us amateurs tend to crash which still easily moves them
![]() I'll just take some countersunk screws, put them in the drill, and then grind off some. That way I can fit two beside each other and it'll stay put.
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
![]() |
|
|