Go Back   oOple.com Forums > Car Talk > Tamiya

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #8  
Old 07-01-2010
super gripper's Avatar
super gripper super gripper is offline
Member
 
Join Date: Oct 2009
Location: Wiltshire
Posts: 231
Default

Quote:
Originally Posted by muratti View Post
Thanks for all your answers. Does it mean i first drill in a hole in the cap, the fill the damper completely full and then put the cap on, fully push the piston so that the oil which is too much can come out of the hole and then screws the blled screw in? Is that correct?
If i donīt use the bleed screw method the secret is to fill the completely full?
this is on another thread but here is how I do it:-

I have not drilled out the hole for the bleed screw, i set the dampers without doing that.

i fill the dampers 2/3 then slowly raise the piston allowing the trapped air to escape while making sure the piston does not break the surface of the oil.
when all the air has escaped i then fill the damper cylinder to the top. the oil at the top should look concave.
pull the piston all the back down.
top up cylinder if necerssary.
screw cap on.
hold the threaded portion of the piston and push all the way up to your fingers.
when you let go the piston should come back half way down by itself.
damper set.
easy.

hope this helps

I have done it this way for over 20 years and never had a problem.
__________________
__________________
Tamiya TRF502x & Vega 201

Titchfield Off Road Club Hants

www.huntersystems.co.uk
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 09:56 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
oOple.com