Go Back   oOple.com Forums > General > Electrics

Reply
 
Thread Tools Display Modes
  #1  
Old 20-01-2012
Rick-J Rick-J is offline
Member
 
Join Date: Jan 2011
Location: Warwickshire
Posts: 80
Default AA Batteries

What are the best AA Rechargeable batteries for an old KO transmitter. Some seem to drop voltage very quickly and my transmitter does not like low voltage. Any suggestions. Thanks
Reply With Quote
  #2  
Old 20-01-2012
VintageRacer's Avatar
VintageRacer VintageRacer is offline
Senior Member
 
Join Date: Jul 2007
Posts: 541
Default

Get some new hybrid nimh, their unused discharge rate is much lower and they retain about 80% of charge even after 12 months on the shelf (at least that's what is quoted). I find they last well in our transmitters. Most manufacturers have their own brand name (eneloop for example). I buy from 7dayshop.com who do their own brand version at a good price.
__________________
Team C TC02c - My son breaks it, I fix it.
Reply With Quote
  #3  
Old 20-01-2012
JCJC's Avatar
JCJC JCJC is offline
Mad Member
 
Join Date: Nov 2005
Location: Oxon
Posts: 1,663
Default

These Vapex green instants are good, don't discharge to much when not in use: http://www.vapextech.co.uk/acatalog/...eries.html#a20

but can you not find lipo ?
Reply With Quote
  #4  
Old 20-01-2012
Rick-J Rick-J is offline
Member
 
Join Date: Jan 2011
Location: Warwickshire
Posts: 80
Default

I have a 40 mhz Ko Esprit II it has two separate battery compartments 4x AA 8x AA in total. It has no connectors just normal AA connections so I dont think you can get a lipo?
Reply With Quote
  #5  
Old 21-01-2012
CrashBangWallop CrashBangWallop is offline
Member
 
Join Date: Mar 2010
Location: Essex
Posts: 263
Default 9 cells

As the 8 usual 'dry' cells are 1.5v nominal = 12 volts as a pack and rechargeable AA cells are 1.2v nominal you can, if you can fit them in run with 9 AA rechargeable cells = 10.8 volts, this will stop your TX dropping out as a lot of modern TX's, Futaba 3VCS for example the low battery alarm sounds at 9.6 volts which is = to 8 nimh cells at nominal voltage.

Just dont go mad with trying to get the volts up too high in a 9 cell 10.8 volt rechargeable pack as this can cause damage - slow charge them and check the voltage before installing them - no more than say 12.5 volts max.
Reply With Quote
  #6  
Old 21-01-2012
Alan Reeves's Avatar
Alan Reeves Alan Reeves is offline
Senior Member
 
Join Date: Dec 2011
Location: Hazel Grove, Stockport
Posts: 450
Default

Quote:
Originally Posted by Rick-J View Post
I have a 40 mhz Ko Esprit II it has two separate battery compartments 4x AA 8x AA in total. It has no connectors just normal AA connections so I dont think you can get a lipo?
You can dismantle it and remove the wires to the terminals so you can solder the + and - wire on each side to two seperate battery packs and recharge through the jack plug.
Reply With Quote
  #7  
Old 21-01-2012
Conrad's Avatar
Conrad Conrad is offline
Senior Member
 
Join Date: Apr 2008
Location: Fife, Scotland
Posts: 473
Default

Any low self discharge AA, they are usually around 2100mah in capacity. I highly recommend the Sanyo Eneloop's which I bought for about £14 delivered for 8 on amazon during the summer. They done almost a full six months of racing once a week without needing charged.
__________________
[swithracing.co.uk] - Swith Racing
Reply With Quote
  #8  
Old 21-01-2012
mark christopher's Avatar
mark christopher mark christopher is offline
Spends too long on oOple ...
 
Join Date: Jan 2007
Location: haxey, doncaster
Posts: 7,787
Send a message via MSN to mark christopher
Default

get these, job done http://www.vapextech.co.uk/acatalog/...eries.html#a20
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD
Reply With Quote
  #10  
Old 21-01-2012
Neil Skull's Avatar
Neil Skull Neil Skull is offline
Mad Member
 
Join Date: May 2008
Posts: 1,047
Default

Team Orion AA Nimh. 2700 mah

http://www.modelsport.co.uk/orion-27...products/29954

__________________


Kyosho UK

www.kyoshoeurope.com
Reply With Quote
  #11  
Old 22-01-2012
JCJC's Avatar
JCJC JCJC is offline
Mad Member
 
Join Date: Nov 2005
Location: Oxon
Posts: 1,663
Default

or stick with good 'dry' batteries,
http://www.toolstation.com/shop/Elec.../sd2450/p51998

would keep you going for a while.
Reply With Quote
  #12  
Old 26-01-2012
Rick-J Rick-J is offline
Member
 
Join Date: Jan 2011
Location: Warwickshire
Posts: 80
Default

Thanks for the replies. The problem I have is that if the batteries drop down to 10.4v then the range drops and I get interference at the top end of the track. Is this normal?
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 08:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
oOple.com