|
#81
|
||||
|
||||
Wow, makes me wish I hold onto my XX4 WCE.
|
#82
|
||||
|
||||
xx4
Awsome work there you really did some work on this specially the esc tidy.
Now wish i not sold mine. Great work tho
__________________
Losi xx Vintage (Rc10stealth Optima mid turbo Cougar works Losi 8E Tuggy brushless 4 boys(will be expensive in rc world)
|
#83
|
|||
|
|||
Can anyone shed any light on how to weight up the XX4? I bought the manutech weights and they are far too heavy and in the wrong place altoghether. You can happily run lipos in the XX4 with 30-40g of total additional weight around the cells - 120g is far too much. So far Ive put 40g inside the front belt tunnel, 30g beside the spur gear spy hole, and 10g under the clicker spy hole, and 20g under each lipo. It's getting there, but still not quiet right. Any advice from anyone?
__________________
www.facebook.com/racewayone RACEWAYONE :: LMR :: MIBOSPORT :: RC CONCEPT :: SMD Trader Feedback: http://oople.com/forums/showthread.php?t=81070 |
#84
|
||||
|
||||
I simply prefer no weights added at all, no matter the surface. I just put very little lead on the outside of the tunnel / inside of the saddle pack LiPos to get it legal.
Low weight also saves the belts, which are very narrow for todays performance (snap easily). I do this with the std. Worlds setup (see manual). Plus Ellis' steering mod. And front diff, no one-way. It drives amazingly!
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#85
|
|||
|
|||
Quote:
So I've added 110 grams between the front belt housing, around the bellcranks and either side of the slipper shaft. It's much better - about 5% quicker - but still not fully there. I'm going to copy Danny McGee's weighting now - as below - basically relocating the esc behind one of the lipo cells. hoping for an improvement.....
__________________
www.facebook.com/racewayone RACEWAYONE :: LMR :: MIBOSPORT :: RC CONCEPT :: SMD Trader Feedback: http://oople.com/forums/showthread.php?t=81070 |
#86
|
||||
|
||||
I didn't run so much my XX4 but I already break a chassis on the front end, on one of the two "ears" which hold thread inserts for mounting the front bulkhead
I don't know if someone had already done the mod I made, but here it is described below. So on a new chassis I decided to modify it by drilling two additional hole in order to insert longer front arm hinge pin in the bulkhead. First mod, I used two old 1.2" rear shock shafts where I cut the threaded tips. On the following picture, one is cut and one is still uncut) Then with an 1/8" drill bit through the bulkhead I drilled the chassis: Here are some pictures with long hinge pins in place: Hope now it will prevent any ear breakage. I suppose I will break more front arms due to rigidify the the bulkhead but arms are less expensive than chassis and much more easy to replace than chassis.... Just my two cents
__________________
http://www.mid44.com/ |
#87
|
|||
|
|||
I think you'll eventually crack the chassis with the hole you've made.
|
#88
|
||||
|
||||
Heard today that the XXX4 is now finally discontinued. Maybe now the wait for an updated XX4 is soon over!!!
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#89
|
||||
|
||||
Quote:
It sounds good SHY
__________________
http://www.mid44.com/ |
#90
|
||||
|
||||
What cars are you running now Olivier?
__________________
Life's too short to go slow! www.ymr.no Tech Tips, HopUps & Bling Xray 2014 XB4 4WD & 2WD | B4 FTW Night Fox XL | Mugen MRX-5 | RB | Futaba 3VCS FASST | Faskolor Visit my showroom |
#91
|
||||
|
||||
here's my XX-4 with lipo saddle ................
__________________
atomic carbon & RED |
#92
|
|||
|
|||
Anyway, your setup is something to marvel at!!
|
#93
|
|||
|
|||
Looking good...pretty tidy! I definitely like it!
|
#94
|
||||
|
||||
Thanks for your watching and team losi is my part of favorite ...........
__________________
atomic carbon & RED |
|
|