UAC50 Charger running off 12v....

[Boons]

Morning all,

One of the clubs I attend runs a 12v system for the chargers. In my bag of connectors which came with my charger is a set of croc clips with the round adaptor end to plug in the 12v socket on the charger. The connecting block at the club takes 4mm male bullets.

I assume it would be ok to simply remove the croc clips and replace with bullets? The standard wire should be ok?

Cheers all

[cutting42]

Yup, you will be fine to do this.

[Boons]

Thank you Sir, very kind

Originally Posted by cutting42

Yup, you will be fine to do this.

[i4n]

That's exactly what I've done to plug into my 12v distribution board.

Just be careful when you're soldering the bullets on as it's PVC insulated wire which melts very, very easily. If you do have an accident a little bit of heatshrink sorts it out nicely.