|
||
|
 |
|
||||||||||||||||||
|
#1
22-09-2008
|
||||
|
||||
B4 Factory Team Front Wheel Screw
Just put my front wheels on, the screws for holding them seem to have a very small head, as if the wheels could pop off over them, is that right or should I run washers too??
|
|
#2
22-09-2008
|
|||
|
|||
|
The wheel bearing will not go over that screw head, but I do understand your concerns, I thought the very same when I first built my X6........
But I still opted to fit the optional titanium axles from Lunsford since they used a good old fashioned solid nut!
__________________
 ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
|
#4
23-09-2008
|
|||
|
|||
|
We should have, I can check for you in the morning if you wish (well later today actually since it is 1:15am already)
__________________
ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
 |
|
|
Team Associated
Linear Mode
