|
#1
|
|||
|
|||
Centro C4.1 Chassis
I have picked up a well used Centro off ebay, It has a steel chassis on it and a second used one was thrown in the box with it, I have put one up against the other and they are the same size and all the holes are in the same place, but the one on the car has 2 bends on it (one where the servo would go and a bigger one where the front arms connect) and the other one is flat until it bends at the front arms.
Are both these chassis correct but different versions, or has somebody just stuffed it in to a wall and flogged it on, Thanks for any help Mark |
#2
|
|||
|
|||
Far as I know there should only be one bend in for the front kick up, other then that it should all b flat
|
#3
|
|||
|
|||
It will be aluminium. They do bend on impact quite easily. It should be flat except for front kick up. Just bend it back over the end of a bench or something, it'll be ok.
|
#4
|
|||
|
|||
Thanks everyone, Will swap it for the one in the box, and straighten this one back up as a spare,
Thanks again Mark |
|
|