|
|||||||||||||||
|
#1
|
|||
|
|||
|
I have just got hold of an original A stamped RC10 Gold tub. It came with the original bronze bushes. I bought an Avid bearing set for it and I'm having problems with drive output bearings in the drive cups.
Is there a trick to inserting these? They're really tight fit and I don't want to wreck the new bearings putting them in. Thought about heating them up in a cup of boiling water then trying to insert the bearings. Any help greatly appreciated.... |
|
#2
|
||||
|
||||
|
Put them in the freezer for 15 min and try that
__________________
My feedback feel free to add anything http://www.oople.com/forums/showthre...863#post861863 |
|
#3
|
|||
|
|||
|
Thanks peakey. I'll have a go and see what happens.
|
|
#4
|
|||
|
|||
|
Bearings in the freezer and Drive cups in boiling water eventually gave just enough to get them in. I think a safe description of the tolerances would be FT.
|
|
#5
|
||||
|
||||
|
Well at least you got them in
__________________
My feedback feel free to add anything http://www.oople.com/forums/showthre...863#post861863 |
|
#6
|
|||
|
|||
|
Quote:
|
|
#7
|
||||
|
||||
|
As I understand he was having trouble getting the bearings inserted in the plastic hubs, and didn't want to force these in.
|
|
#8
|
||||
|
||||
|
I thought they were internal ones not external
![]()
__________________
My feedback feel free to add anything http://www.oople.com/forums/showthre...863#post861863 |
|
#9
|
|||
|
|||
|
Peakey is correct. To clarify, this was the pushing the bearings into the Gearbox internal outdrives. I therefore needed the cups to expand and the bearing to contract to insert the bearings in the cups.
|
|
#10
|
|||
|
|||
|
Quote:
|
|
#11
|
||||
|
||||
|
__________________
My feedback feel free to add anything http://www.oople.com/forums/showthre...863#post861863 |
![]() |
|
|