|
||
|
 |
|
||||||||||||||||||
|
#1
27-02-2009
|
||||
|
||||
Batlet setup
Has anyone got a decent setup for Batley that they could share?
...for the X6 
|
|
#2
27-02-2009
|
||||
|
||||
|
From me, the short answer is no, as last year I ran 4wd at batley (and 2wd at Worksop). Usual kind of setup should be fine though. The hall floor can vary somewhat so there can be quite a difference between the carpet and polished floor. Fortunatly a good balance on different surfaces is one of the plus points of an X6 so you should be fine.
__________________
 Nortech is ACE!
|
|
#3
27-02-2009
|
||||
|
||||
|
What are we talking when you say 'usual kind of set up' Dan?
Mines second hand so want to make sure its right. 
|
|
#4
02-03-2009
|
||||
|
||||
|
The usual Green/blue/black front spring ~ 30wt oil and a red piston and 25wt in the rear with a red piston (i am running a 3200 lipo) pink rear spring. Anti squat is personal preference. E speed hangers. A rear bar for me but again personal preference
You should be pretty close with that. the rest is just standard.
|
|
#5
02-03-2009
|
||||
|
||||
|
Dan's winning set-up from yesterday looked good.
He was giving it full beans, looked every inch a winner to me.
__________________
SP12/RC10/XLS/JRX-2/XX/XXCR/XXCR-KE/XXX/XXXBK2/CR2/Xpro/B4/XX4/XXX4/X5/X11/DEX410/DEX210/DNX408/8ight/VW Golf GTI MK2/VW Golf TDI Wagon/Ovlov V70 D5/VW Beetle II (registered to Carrie)/Bailey Ranger/(does anyone read this bullshit?)/Creda Tumble2/HotPoint FE800/BOSCH SGS45C02GB/Dyson DC04/new patio doors & windows/freshly painted bannister rail & skirting boards, baby.
|
|
#6
02-03-2009
|
||||
|
||||
|
Quote:
__________________
SP12/RC10/XLS/JRX-2/XX/XXCR/XXCR-KE/XXX/XXXBK2/CR2/Xpro/B4/XX4/XXX4/X5/X11/DEX410/DEX210/DNX408/8ight/VW Golf GTI MK2/VW Golf TDI Wagon/Ovlov V70 D5/VW Beetle II (registered to Carrie)/Bailey Ranger/(does anyone read this bullshit?)/Creda Tumble2/HotPoint FE800/BOSCH SGS45C02GB/Dyson DC04/new patio doors & windows/freshly painted bannister rail & skirting boards, baby.
|
|
#7
02-03-2009
|
||||
|
||||
|
It just makes no difference which one you use Stu.
We actually went from a black to a green during the 24hr race whilst doughty was doing a stint and he didn't notice, he was more concerned about the yellow wheels on the new front end 
|
|
#8
02-03-2009
|
||||
|
||||
|
Dan was like a man on the edge, that was a true display of driving excellence I have to say.
__________________
If your PM doesn't at first succeed - try, try again. I'll reply in the end, honest. 
|
|
#9
02-03-2009
|
||||
|
||||
|
Quote:
Attached setups from X6 and also X5 which I ran a couple of times to get a setup ahead of the supercup. My X6 was particularly good though, only suffering from a lack of drive on the tight section coming onto the straight, I think that was fubar tyres though which have since been retired to a bed of acetone. Shame I can't do the regional next week.
__________________
Nortech is ACE!
|
|
#10
02-03-2009
|
||||
|
||||
|
Nice one Dan I take it you won then? Any results anywhere?
__________________
WWW.SERVOSHOP.CO.UK
|
|
#11
02-03-2009
|
||||
|
||||
|
What size holes are on the red pistons...and how many holes?
I'm not running losi shocks, so want to make sure I get as close as.
|
|
#12
02-03-2009
|
||||
|
||||
|
3 hole tel, number 56 sized drill.
This chart is good for comparing the pistons http://www.petitrc.com/setup/OffRoad...istonChart.pdf
|
|
#13
02-03-2009
|
||||
|
||||
|
Red pistons are 3 x 56 holes so id say close to a AE no2
__________________
WWW.SERVOSHOP.CO.UK
|
 |
|
|
X-Factory
Linear Mode
