|
||
|
 |
|
||||||||||||||||||
|
#1
21-04-2009
|
||||
|
||||
DX3R / S
do these transmitters suffer from the thumbwheel adjuster breaking the small pin of the wheel?
__________________
o0ple Trader Feedback NE Venue's New & Old my space on YouTube CFR RCTV Channel Glenn Atterton BRCA 2005 1/10th Off-Road Veterans Champion LMP12 National Champion 2003/2004 / F3 class 
|
|
#2
21-04-2009
|
||||
|
||||
|
Done a repair with super glue and it's working so far
When I placed the roller in the adjuster pot the other end was miles away from the micro switch. Re-soldered the pot to reduce the angle the roller has to be pressed. Now it's almost touching and the roller doesn't need to be pressed as far so reducing the stress on the small pin of the roller. For the time being I'm pressing the left side of the roller nearer to the micro switch.  Bad design if you ask me, asking the small pin to do two duties going to see what Horizon Hobby UK and Spektrum say
__________________
o0ple Trader Feedback NE Venue's New & Old my space on YouTube CFR RCTV Channel Glenn Atterton BRCA 2005 1/10th Off-Road Veterans Champion LMP12 National Champion 2003/2004 / F3 class
|
|
#3
21-04-2009
|
||||
|
||||
|
Me and Rich D, had problems (Rich D Broke it
  Just replaced it at local modelshop and it was my christmas present  :P
__________________
Matt Chandler HPI Europe / Hotbodies / Flux / Edit / SMD / HUDY / RC Bearings / MB Models / XtremeFX race paint http://matthew-chandlers-rc--blog.blogspot.com/
|
|
#4
21-04-2009
|
||||
|
||||
|
Quote:
Yes i confess i broke it with the very first push of the button - pretty dire build quality tbh Sorry Matty 
|
|
#5
21-04-2009
|
||||
|
||||
|
Or Someone, With American Thumbs
__________________
Matt Chandler HPI Europe / Hotbodies / Flux / Edit / SMD / HUDY / RC Bearings / MB Models / XtremeFX race paint http://matthew-chandlers-rc--blog.blogspot.com/
|
 |
|
|
Linear Mode
