|
|||||||||||||||
|
#1
|
||||
|
||||
|
On the race that was held @ orebro rc club in Sweden, i was lucky to get those pics on something that i never ever have seen...
This is a cover for the rear end on the new 511 Tamiya.(diff) totaly sealed off from dust, Printed in plastic, i talked to the designer and he showed me those parts and there is onely one word for it´s fit, perfect! ![]() ![]() ![]()
|
|
#2
|
||||
|
||||
|
Cool Thomas that you show this because the genius who made it don't got the time to do it himself
I can tell it worked superbly the whole day and didn't let any gravel what so ever enter the diff house! Not a slightest grain of dirt in there. The genius name is Fredrik Emilsson and My guess is that more of these inventions will appear. BTW, is snap on and no glueing required! |
|
#4
|
||||
|
||||
|
The diff cover has now been used in ny 511 for approx 20 full battery runs during both dusty and wet conditions.
After one the racing sessions the car looked like this http://www.tamiyaclub.com/picturefra...09222743_7.jpg This is how the pulley looks: http://www.tamiyaclub.com/picturefra...09222743_8.jpg And on the inside: http://www.tamiyaclub.com/picturefra...09222743_9.jpg Note that I also use a protective seal. This of course helps to keep the diff clean on the inside. I´ve also made the diff cover compatible with a reversed damper setup: http://www.tamiyaclub.com/picturefra...09222743_1.jpg You simply flip a part of the upper cover and Vóila! I´m in the final stage with the 501X cover. I expect to have it ready next week. Same goes for the lipo solution for the 511. |
![]() |
|
|