|
||
|
 |
|
||||||||||||||||||
|
#1
17-06-2009
|
||||
|
||||
why?
why do we put foam under the ball stud's below the ball cup's?
and is there anywhere to buy the stuff is it work's as i have not tryed it yet  cheer's nick 
|
|
#2
17-06-2009
|
||||
|
||||
|
It's to stop dirt entering between the ball and stud so they don't wear so much.
No idea of the part numbers but AE and Losi definately make it if you want nice neat ones otherwise you could try making your own out of a bit of foam.
__________________
Lets Off Road!
|
|
#3
17-06-2009
|
|||
|
|||
|
Azarashi do some too, with over twice as many in the packet (42)
__________________
 ORCA - LC RACING - RUDDOG PRODUCTS - JCONCEPTS - ALPHA PLUS - TEKIN RACING - ULTRAPOWER AVID R/C - VAMPIRE RACING - EXOTEK RACING - LUNSFORD RACING - X-FACTORY - TUNING HAUS - WTF AME - RAGE R/C - REVOLUTION DESIGN RACING PRODUCTS - McKUNE DESIGN - TEAM AZARASHI X-PARTZ - PHAT BODIES - RACERS EDGE - RM2 - DIRT RACING PRODUCTS - DMS INSERTZ TKR GRAPHICS - BF MATERIALS - BATAN - DMS PARTZ - TEAM AJ Tel : (01923) 816636
|
|
#4
17-06-2009
|
||||
|
||||
|
Some say these hold muck against your balls, wearing them faster. I think it depends on the atmosphere - if its wet and muddy then they will soak it up, if dusty then they will defend grit getting to the balls.
|
|
#5
17-06-2009
|
||||
|
||||
|
Quote:
|
|
#6
17-06-2009
|
|||
|
|||
|
Quote:
Not literally though....
__________________
Team Losi Racing, Horizon Hobby TLR 22 5.0, TLR 22X-4, TLR 22-4, 22-4 2.0 Atomic Carbon S2, S44, Vega B4.1 Trader feedback: http://www.oople.com/forums/showthread.php?t=19374
|
|
#7
17-06-2009
|
||||
|
||||
|
Quote:
|
 |
|
|
Linear Mode
